Verilink WANsuite 6450 (34-00326) Product Manual Uživatelský manuál Strana 123

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 205
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 122
VT100 Interface 4-15
Figure 4.14
Span Endpoint Maintenance Screen
The Span Endpoint Maintenance parameters are described below.
Loopback Type
Specifies loopbacks for the associated segment endpoint.
Values: No Loopback, Normal Loopback
Default: No Loopback
Loopback Timeout
Specifies the timeout value in minutes for loopbacks initiated at this endpoint.
A value of 0 disables the timeout.
Tip Ring
Indicates the state of the tip/ring pair at the associated segment endpoint.
Power Source
Indicates the DC power source being used by the associated unit.
Restart Endpoint
Enables the manager to trigger a soft restart of the SHDSL line at the
associated segment endpoint. Set this object to “restart” to initiate a restart. A
restart will occur after approximately 5 seconds.
Values: Ready, Restart
Default: Ready
Selecting the “Performance” prompt on the Span Endpoint Details screen will
display the screen shown in Figure 4.15.
Zobrazit stránku 122
1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 204 205

Komentáře k této Příručce

Žádné komentáře