Verilink 210 (34-00196) Product Manual Uživatelský manuál stáhnout pdf (Strana 5)

The differences between the 200 and 210 CSU units are summarized as follows:

• Configuration switch S2 is found only on the 200 CSU.

• Position S1-7 (switch S1, position 7) is a spare on the 200 CSU.

On the 210 CSU, position S1-7 is used to enable the ‘Transparent’ mode.

• The front panel ‘FAR’ LED indicator is installed only on the 200 CSU.

1.1 Specifications

Network Interface

Line Rate: 1.544 Mb/s (± 50 bps)

Line Framing: D4 or ESF

Line Code: AMI or B8ZS

Line Impedance: balanced 100 Ω (± 5%)

Input Signal: DS1, +1 to -30 dB (ALBO)

Output Signal: 3.0 V, ±15%, base-peak into 100 ¾

Line Build Out: 0, -7.5, -15, and -22.5 dB attenuation

Line Protection: 1000 V lightning, fused input/output

Jitter Control: per TR62411 and T1.403

Pulse Density: per TR62411

Equipment

Interface

Line Rate: 1.544 Mb/s (± 50 bps)

Line Framing: D4 or ESF

Line Code: AMI or B8ZS

Line Impedance: balanced 100 Ω (± 5%)

Input Signal: DSX1 to 655 feet

Output Signal: Selectable DSX1 signal level from 0 to 655 feet

Line Protection: 1000 V lightning, input/output

DTE Line Coding: Position S2-3 sets the DTE line coding, including conversion.

- AMI B - B8ZS

Network Line Framing: Position S2-4 sets the CSU to the framing of the network

line. In the ESF mode, the unit responds to all T1.403 or 54016 messages.

- ESF B - D4

DTE Line Framing: Position S2-5 sets the CSU to the framing of the DTE line.

A - ESF B - D4

PRM: Position S2-7 enables/disables sending a PRM (performance report message)

during AIS. If the unit detects a loss of sync from the DTE, an unframed all ones signal

is generated to the T1 facility. If Switch S2-1 is set for T1.403 operation, the unit inter-

rupts the AIS signal with a PRM once a second.

- PRM enabled B - PRM disabled

TxPORT 210 CSU

Mode

NET

DTE

NET

DTE

Spare

PRM

54321 6 7

Mode

NET

DTE

NET

DTE

Spare

PRM

54016

AMI

ESF

Enable

T1.403

B8ZS

Disable

LOOP NORM

CSU

PWR DTE NET LOOP

PRODUCTIVITY SERIES 210

TRANSPORT

Configuration Switch S2

Note: This switch

is provided only on

the 200 CSU

1 2 3 4 5 6 7 8 9

Komentáře k této Příručce

Žádné komentáře

Verilink 210 (34-00196) Product Manual Uživatelský manuál Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Verilink 210 (34-00196) Product Manual