Verilink AS56/56Plus (896-502588-001) Product Manual Uživatelský manuál stáhnout pdf (Strana 25)

AS56 and AS56

Plus

User Manual

3-1

Chapter

3 Configuring and Installing the

Access Syst em56

If you have purchased the AS56

Plus

unit, you can select from two

Network Interface Operating Modes:

■

AS56 — factory default (56/64 kbps CSU/DSU)

■

AS56

Plus

— T1 CSU/DSU

Obviously, you must first insert the cable into the correct port. However,

changing the operating mode can only be accomplished using the ASCII

console interface. Before proceeding any further, refer to the procedures

Terminal Configuration,

on page 6-5, and

Terminal Operation,

on page

6-7.

WARNING

The following rules should always be followed when connecting

telephone equipment and/or wiring:

1. Never install telephone wiring during a lightning storm.

2. Never install the telephone jacks in wet locations unless the jack is

specifically designed for wet locations.

3. Never touch insulated telephone wires or terminals unless the

telephone line has been disconnected at the network interface.

4. Use caution when installing or modifying telephone lines.

Access Sys tem56 units should

not

be connected to the network until after

it has been completely configured and has successfully passed self test.

NOTE

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 129 130

Žádné komentáře

Verilink AS56/56Plus (896-502588-001) Product Manual Uživatelský manuál Strana 25