Verilink C100 (880-502893-001) Product Manual Uživatelský manuál stáhnout pdf (Strana 39)

Configuration Using the DIP Switches

06/17/97

C100 and C150 T1/FT1 CSU/DSU

3-15

Programming the DS-0s and DSX-1s (C100 and C150)

Switch packs 5, 6, and 7 settings are required for both the C100 and

C150.

DS-O assignment

Switch packs 5, 6 and 7 are used to determine whether a DS-0 is give

to the Synchronous Channel or the DSX-1. There are twenty-four DS-0s

in a T-1 frame and these DS-0s may be assigned to the Channel or DSX-

1 on a contiguous or non-contiguous basis.

If the switch position is Off (rocker arm down towards the front panel),

the DS-0 is not used or assigned to the DSX-1, depending on whether

the unit is a C100 or C150.

If the switch position is On, the DS-0 is assigned to the Synchronous

Channel. Even when the DSX1 interface is disabled, this selection must

be made in order to determine how many DS-0s go to the Synchronous

Channel

The programming of the DS-0s must match the DS-0 selection in the

remote unit when they are used on a point-to-point connection or they

must match the DS-0 selection on the Fractional T-1 facility provided

by the T-1 Carrier supplier.

Table 3-6 Switch pack-5: C100/C150 DS0-01 through DS0-08 and C150 DSX1-01 through DSX1-08

12345678 C100 Setting C150 Setting

Off-------DS0-01 not usedDSX1-1

On------- DS0-01 to Channel

Off -----DS0-02 not usedDSX1-2

On ----- DS0-02 to Channel

-Off ----DS0-03 not usedDSX1-3

-On ---- DS0-03 to Channel

--Off ---DS0-04 not usedDSX1-4

- - On - - - DS0-04 to Channel

---Off --DS0-05 not usedDSX1-5

---On -- DS0-05 to Channel

----Off -DS0-06 not usedDSX1-6

----On - DS0-06 to Channel

-----Off DS0-07 not used DSX1-7

-----On DS0-07 to Channel

------OffDS0-08 not used DSX1-8

------On DS0-08 to Channel

Off Off Off Off Off Off Off Off Factory default setting

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 134 135

Žádné komentáře

Verilink C100 (880-502893-001) Product Manual Uživatelský manuál Strana 39