Verilink FrameStart FSM (34-00299.E) Product Manual Uživatelský manuál stáhnout pdf (Strana 17)

About the FrameStart FSM 1-5

The user-activated input control buttons used to access and set configuration

and control options from the LCD menus are defined in the table below:

Rear Panel Connections

The rear panel of the FrameStart FSM has five connectors − POWER,

SUPERVISORY PORT, 10/100 ETHERNET, SERIAL INTERFACE, and NET −

as shown in Figure 1.2. Each of these connectors is described in the

paragraphs below.

Supervisory Port

The SUPERVISORY PORT on the FrameStart FSM is a DB-9 female DCE

connector configured for 8 bits, no parity, and 1 stop bit. Bit rates are

configured through the Web server interface (see Supervisory Screen on

page 3-15) or VT 100 interface (see Supervisory Configuration Screen on

page 4-16). The Supervisory port speed can be set to 1200, 2400, 4800, 9600,

19200, 38400, 57600, or 115200 bps. The initial default rate of the

Supervisory port is 19200 bps.

On power-up, the Supervisory port sends out diagnostic messages at the bit

rate of 115.2 kbps until the Supervisory service acquires the Supervisory port.

These diagnostic messages can disrupt the connected device; however you can

configure the unit to disable their transmission.

Button Description

EXIT

The EXIT button allows exiting a menu option which then places the

unit in the next higher level in the menu hierarchy. If the user is in the

process of editing an option, pressing the

EXIT button exits that screen

without saving any changes. If in the main menu, pressing

EXIT logs

off the unit.

SCROLL

The SCROLL button allows the user to review the available options for

a given level in the menu hierarchy or to scroll through possible

settings for a parameter. The

SCROLL button is also used to set

alphanumerical values, where applicable, by scrolling incrementally

through digits 0–9 or letters A–Z and a–z.

SELECT

The SELECT button allows the user to select the currently displayed

option or value for a given field, and is also used to enter an “edit”

mode for parameters that require user-specified input. Additionally, the

SELECT button is used to confirm certain actions or settings.

Figure 1.2

FrameStart FSM Rear Panel

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 152 153

Komentáře k této Příručce

Žádné komentáře

Verilink FrameStart FSM (34-00299.E) Product Manual Uživatelský manuál Strana 17

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Verilink FrameStart FSM (34-00299.E) Product Manual