Verilink SCC 2020 (880-503268-001) Product Manual Uživatelský manuál stáhnout pdf (Strana 71)

Diagnostics

Verilink SCC 2020 User Manual

-13

With a loopback plug in the network port, any customer equipment

connected to the SCC 2020 (or a data port of any DIU module

assigned to the CSU) should see a loopback condition. If the

customer equipment is capable of reporting errors, it should

indicate that no errors are being received.

A T1 loopback plug can be made by taking a male RJ-45 connector

and placing two short jumper wires where a cable would normally

go. One jumper is placed from pin one to pin five, the other jumper

connects pin two to pin four. See Figure 5-5 for a drawing of a T1

loopback plug.

NOTE:

When using a T1 loopback plug it may be necessary to

temporarily change the timing selection in the CSU. If the

CSU is set to recover network clock it will be trying to recover

a clock it is trying to recover, the clock frequency will drift.

For this test, set the CSU clock source to Internal.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 77

Žádné komentáře

Verilink SCC 2020 (880-503268-001) Product Manual Uživatelský manuál Strana 71