Verilink WANsuite 5230 (34-00304.F) Product Manual Uživatelský manuál stáhnout pdf (Strana 177)

VT100 Interface 4-61

Figure 4.51

Dynamic Route Table Screen

The Dynamic Route Table displays the fields listed below.

Static ARP Table Screen

ARP (Address Resolution Protocol) is used by the router to dynamically

associate a high-level IP address to a low-level physical hardware address.

ARP packets are only sent across a single physical network.

There are some cases when an IP-compatible device does not support ARP or

ARP is deliberately disabled (for security). In these cases, instead of using

ARP to dynamically update the router internal MAC <-> IP Address Table,

this menu can force an entry into that table. This entry never times out.

At least one circuit must be defined to create a Static ARP Table entry

because an ARP entry is always associated with a circuit. The static ARP

table is useful when a Host does not respond to an ARP request. Access this

menu by selecting “Static ARP Table” from the IP Gateway menu.

Field Description

Destination Network to be reached.

If Ndx Interface internal number.

Next Hop IP address used to reach the destination network.

Mask Mask of the destination network.

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 232 233

Žádné komentáře

Verilink WANsuite 5230 (34-00304.F) Product Manual Uživatelský manuál Strana 177