Verilink WANsuite 5230 (34-00304.F) Product Manual Uživatelský manuál Strana 198
- Strana / 233
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
5-2 WANsuite 5260/5230
The table below provides a brief description of the WANsuite 5260/5230’s
LED indicators.
Indicator Description
NET
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights red when the E1 link is down.
The indicator lights amber when the E1 link is up and at least one
configured protocol is not established.
The indicator lights green when the E1 link is up and all configured
protocols are established.
NOTE: TDM is considered a protocol. It is established whenever the E1
link is up.
SERIAL #1
Port in DTE Mode:
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights red when DSR is not active and the configured
protocol is not established.
The indicator lights amber when DSR is not active or the configured
protocol is not established.
The indicator lights green when DSR is active and the configured
protocol is established.
DTR Alarm Enabled (Port in DCE Mode):
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights red when DTR is not active and the configured
protocol is not established.
The indicator lights amber when DTR is not active or the configured
protocol is not established.
The indicator lights green when DTR is active and the configured
protocol is established.
DTR Alarm Disabled (Port in DCE Mode):
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights green when the configured protocol is established.
The indicator lights red when the configured protocol is not established.
SERIAL #2
(5260 Only)
(Same as SERIAL #1)
ALARM
(5230 Only)
This indicator lights red if an alarm condition exists.
The indicator lights
amber if a “yellow” alarm condition exists.
POWER
This indicator lights green when power is applied to the unit.
The indicator lights amber in test modes (Port looped or BERT active).
- WANsuite 1
- 5260/5230 1
- Reference Manual 1
- WANsuite 5260/5230 2
- Table of Contents 5
- Chapter 4 VT100 Interface 7
- Appendix A Specifications 9
- Appendix B SNMP Agent 10
- About this Manual 11
- • Diagnostic error messages 12
- Returning a Unit to Verilink 13
- ABOUT THE WANSUITE 15
- 5260/5230 15
- 1-2 WANsuite 5260/5230 16
- Performance 17
- SNMP Management 17
- About FrameStart Technology 18
- Features Summary 19
- 1-6 WANsuite 5260/5230 20
- Front Panel 21
- Indicator Description 22
- Rear Panel Connections 23
- Ethernet LED Indicators 24
- Power Connection 25
- Power Failure 26
- NSTALLATION 27
- Installation Wizard 28
- Installation 2-3 29
- 2-4 WANsuite 5260/5230 30
- NTERFACE 31
- Layout of Interface Screens 32
- Figure 3.1 33
- Figure 3.2 34
- Figure 3.3 34
- Network Screens 35
- 3-6 WANsuite 5260/5230 36
- Web Server Interface 3-7 37
- Figure 3.5 38
- Performance 24 Hour Screen 39
- Web Server Interface 3-11 41
- 3-12 WANsuite 5260/5230 42
- Current Pin Status 43
- Button Function 44
- Figure 3.10 45
- Supervisory Screen 46
- Adding a Service 47
- Interface Details Button 49
- Type Details Button 49
- Delete Service Button 49
- Figure 3.16 51
- Figure 3.17 52
- Figure 3.18 52
- Figure 3.19 53
- 3-24 WANsuite 5260/5230 54
- Web Server Interface 3-25 55
- Status and Alarms Table 56
- SCADA Details Screen 58
- Figure 3.22 59
- Web Server Interface 3-31 61
- Parameters To Negotiate 62
- CHAP Table 65
- 3-38 WANsuite 5260/5230 68
- Web Server Interface 3-41 71
- Figure 3.37 77
- Top N Details Screen 84
- Circuits Screen 87
- Static Routes Screen 90
- Route Details Screen 90
- Figure 3.48 91
- TCP Server Details Screen 99
- NAT Details Screen 100
- 3-72 WANsuite 5260/5230 102
- Figure 3.61 103
- Figure 3.62 103
- Figure 3.64 104
- Figure 3.63 104
- NAT Ports Screen 105
- Figure 3.66 106
- Figure 3.67 106
- DHCP Server Details Screen 107
- DHCP Hosts Screen 108
- Static Entries Screen 109
- IP Address List Screen 110
- IP Address Status Screen 110
- Software Upgrade 111
- Software Upgrade Screen 112
- WILL NOT be installed 112
- Save/Upload 113
- Password 113
- In-band Management 114
- Frame Relay Network 115
- 3-86 WANsuite 5260/5230 116
- Accessing the VT100 Interface 117
- Screen Components 117
- Cursor Controls 118
- Field Types 118
- Menu Structure 119
- System Screen 120
- Maintenance Reset 121
- Save and Restart 122
- Network Config Screens 123
- Network 2 Screen 124
- VT100 Interface 4-9 125
- Prompt Function 126
- Performance Screens 127
- Serial Screens 128
- VT100 Interface 4-13 129
- Assignments on page A-7 130
- VT100 Interface 4-15 131
- Ethernet (IP Details) Screen 132
- Figure 4.13 133
- Service Table Screen 134
- Service Details Screen 135
- DS0 Monitor Details Screen 136
- DS0 Status and Alarm Table 137
- Channel Table Details Screen 138
- Figure 4.19 139
- Field Description 140
- VT100 Interface 4-25 141
- 4-26 WANsuite 5260/5230 142
- Transmit 144
- Throughput (bits/sec) 145
- PPP Service Details Screen 145
- 4-30 WANsuite 5260/5230 146
- Parameters to Negotiate 147
- PPP Statistics 147
- PAP Table 148
- PAP Table Screen 149
- PAP Details 149
- SCADA Service Details Screen 150
- IP Service Details Screen 151
- Endpoint Table Screen 152
- Endpoint Details Screen 153
- 4-38 WANsuite 5260/5230 154
- DLCI Details Screen 155
- VT100 Interface 4-41 157
- DLCI Status Table 158
- DLCI Statistics Screen 159
- DLCI Table Screen 160
- Service Aware Screen 161
- Rule Configuration Screen 161
- Rule Config Screen 162
- Figure 4.39 163
- SNMP Details Screen 164
- Diagnostics Screen 164
- Test Details Screens 165
- NOTICE: The 2 166
- Figure 4.43 167
- Trap Log Screen 169
- Top Talkers Screen 169
- IP Gateway Screen 171
- RIP Parameters 171
- OSPF Parameters 172
- Circuit Table Screen 172
- Circuit Details Screen 173
- 4-58 WANsuite 5260/5230 174
- Static Route Table Screen 175
- Dynamic Route Table Screen 176
- Static ARP Table Screen 177
- ARP Details Screen 178
- Trusted Neighbors Screen 179
- Area Table Screen 179
- Area Details Screen 180
- Virtual Link Table Screen 181
- Virtual Link Details Screen 182
- TCP Server 183
- TCP Server Screen 183
- TCP Connection Table Screen 184
- Static TCP Trans Table Screen 187
- NAT Port Details Screen 189
- Static UDP Trans Table Screen 190
- Figure 4.69 191
- 4-80 WANsuite 5260/5230 196
- Description of Front Panel 197
- The indicator lights 198
- LCD Front Panel Operation 199
- Interface Conventions 200
- Information Element 201
- Alarms Menu 201
- Status Menu 202
- DTR Alarm 203
- Reset Timer 204
- Reset Alarms 204
- Performance Menu 204
- (read-only fields) 204
- Maintenance Menu 205
- Serial Maintenance Menu 206
- Configuration Menu 208
- TCP/IP Configuration Menu 208
- IP Address 208
- Subnet Mask 209
- Gateway Address 209
- DHCP Client 209
- Figure 5.14 210
- • Thru − Allocated to NET 2 211
- Figure 5.16 212
- 5-18 WANsuite 5260/5230 214
- Figure 5.17 215
- Utilities Menu 216
- Log Out Menu 217
- 5-22 WANsuite 5260/5230 218
- PECIFICATIONS 219
- Serial Interface(s) 220
- IP Gateway 220
- Management Interfaces 220
- Diagnostics 220
- Figure A.1 221
- Figure A.2 221
- Mechanical 222
- Environmental 222
- Industry Listings 223
- Standards 223
- Ordering Information 224
- Optional Equipment 224
- Connector Pin Assignments 225
- Function Abbrev. Direction 226
- Pin Ethernet Interface 226
- Assignments 227
- A-10 WANsuite 5260/5230 228
- Introduction 229
- SNMP Configuration Parameters 229
- SNMP MIBs 229
- SNMP Trap Configuration 230
- SNMP Agent B-3 231
- B-4 WANsuite 5260/5230 232
Související produkty a manuály pro Počítačový hardware Verilink WANsuite 5230 (34-00304.F) Product Manual
Počítačový hardware Verilink WANsuite 5650 (34-00314.E) Product Manual Uživatelský manuál
(68 stránky)
(68 stránky)
Počítačový hardware Verilink WANsuite 5370 (34-00310.D) Product Manual Uživatelský manuál
(235 stránky)
(235 stránky)
Počítačový hardware Verilink WANsuite 6x30 (34-00315.B) Product Manual Uživatelský manuál
(181 stránky)
(181 stránky)
Počítačový hardware Verilink WANsuite 6450 (34-00326) Product Manual Uživatelský manuál
(205 stránky)
(205 stránky)
Počítačový hardware Verilink 1024 Chassis (CG) Configuration/Installation Guide Uživatelský manuál
(2 stránky)
(2 stránky)
Počítačový hardware Verilink 1040 Power Shelf (CG) Configuration/Installation G Uživatelský manuál
(1 stránky)
(1 stránky)
Počítačový hardware Verilink 1041 (CG) Configuration/Installation Guide Uživatelský manuál
(2 stránky)
(2 stránky)
Počítačový hardware Verilink 1042 (CG) Configuration/Installation Guide Uživatelský manuál
(2 stránky)
(2 stránky)
Počítačový hardware Verilink 1050 (CG) Configuration/Installation Guide Uživatelský manuál
(2 stránky)
(2 stránky)
Počítačový hardware Verilink 1051-1 Chassis (CG) Configuration/Installation Gui Uživatelský manuál
(2 stránky)
(2 stránky)
Počítačový hardware Verilink 1051-2 Chassis (CG) Configuration/Installation Gui Uživatelský manuál
(2 stránky)
(2 stránky)
Počítačový hardware Verilink 1060 Broadcast Card (CG) Configuration/Installatio Uživatelský manuál
(2 stránky)
(2 stránky)
Počítačový hardware Verilink 1060A Broadcast Card (CG) Configuration/Installati Uživatelský manuál
(2 stránky)
(2 stránky)
Počítačový hardware Verilink 1061 Multicast Card (CG) Configuration/Installatio Uživatelský manuál
(2 stránky)
(2 stránky)
Počítačový hardware Verilink WANsuite 7205 (34-00317.B) Product Manual Uživatelský manuál
(221 stránky)
(221 stránky)
Počítačový hardware Verilink 1200 Rack Pwr Spply (IG) Configuration/Installatio Uživatelský manuál
(2 stránky)
(2 stránky)
Počítačový hardware Verilink 1251 (CG) Configuration/Installation Guide Uživatelský manuál
(2 stránky)
(2 stránky)
Počítačový hardware Verilink 1250 (CG) Configuration/Installation Guide Uživatelský manuál
(2 stránky)
(2 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.037 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce