Verilink WANsuite 6x30 (34-00315.B) Product Manual Uživatelský manuál Strana 143

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 181
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 142
VT100 Interface 4-45
Figure 4.41
Routes Details Screen
Endpoint
End poin t name (o r int erfac e) thr ou gh wh ich to se nd th e IP p acket t o reac h the
Target IP Address.
Target IP Address
Represents the target network that you want this router to reach.
Values:
0.0.0.0
255.255.255.255
Default:
0.0.0.0
Target IP Mask
Mask of the target network.
Values:
0.0.0.0
255.255.255.255
Default:
0.0.0.0
NOTICE:
Setting the Target IP Address and Target IP Mask to 0.0.0.0 defines
the
default route for this unit. Because a unit can have only one default
route, if a default route is configured as a WAN route on the above
screen, the Gateway address configured on the 10/100 Ethernet screen
must be left blank. Likewise, if a Gateway is configured on the 10/100
Ethernet screen, it becomes
the
default route, and no WAN default route
can be configured on a Static Route.
Next Hop IP Address:
IP address of the next device in the route.
Cost
Cost of using that route.
Values:
0
65535
Default:
1
Route Status
Indicates whether or not the current route is enabled.
Values:
Enable, Disable
Default:
Enable
Dynamic Route Table Screen
Access this menu by selecting the “Dynamic Route Table” prompt on the
Static Route Table screen. This table shows both dynamic and circuit tables.
Zobrazit stránku 142
1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 180 181

Komentáře k této Příručce

Žádné komentáře