Verilink WANsuite 7205 (34-00317.B) Product Manual Uživatelský manuál stáhnout pdf (Strana 141)

VT100 Interface 4-19

DS0 Monitor Details Screen

Select a Network TDM service on the Services screen to view the DS0

Monitor Details Screen (Figure 4.15). This screen lets you configure what are

considered high and low DS0 utilization parameters, and then reports alarms

if the monitored statistics rise above or fall below those specified settings.

This helps determine customer load patterns so that channel bandwidth can be

reallocated as necessary.

Figure 4.15

DS0 Monitor Details Screen

Number of DS0s

Number of active DS0s (0−31) assigned to this service.

Alarm Reset Timer

Number of seconds that an alarm condition must not be present before an

alarm is reset. Zero (0) indicates the Alarm Reset Timer is disabled.

Values: 0−900

Default: 30

High Utilization %

Lets you configure as a percent what is considered high utilization.

Values: 1−100

Default: 100

High Threshold (sec)

Lets you configure a high-utilization threshold (in seconds), above which an

alarm will report.

Values: 0−900

Default: 0 (Disabled)

End of Day Low

Utilization %

Lets you configure as a percent what is considered low utilization at the end

of the day. If the utilization is below this level when the day ends, an alarm

reports.

Values: 0−100

Default: 0 (Disabled)

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 220 221

Žádné komentáře

Verilink WANsuite 7205 (34-00317.B) Product Manual Uživatelský manuál Strana 141