Verilink PRISM 3101 (34-00212) Product Manual Uživatelský manuál stáhnout pdf (Strana 15)

Installation 2-5PRISM 3101/3102

Power Connection

AC powered units are powered by a 110 VAC captive power

supply. There is no power switch.

DC powered units have two terminal block connections

labeled positive (+) and negative (-) that accept wire sizes

from 12-gauge to 20-gauge. Either polarity (positive or neg-

ative) may be referenced to ground.

The unit is protected from reverse

power connection but will not oper-

ate until power is properly connected

according to the marked polarities (posi-

tive-positive and negative-negative).

Power Failure

The PRISM 3101/3102 provides non-volatile memory

retention of the unit configuration in case of a power failure.

This feature allows the unit to automatically restore normal

service following a power loss. When power is applied to

the unit, the front panel indicators flash for approximately

five seconds as the unit starts up.

Network Management

The PRISM 3101/3102 is compatible with the TxPORT

8100A Site Controller as a remote or ‘far end’ element. The

8100A can be used to manage TxPORT network access

products. Network management is performed through the

SUPV port, SLIP port, or the LAN port.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 46 47

Žádné komentáře

Verilink PRISM 3101 (34-00212) Product Manual Uživatelský manuál Strana 15