Verilink S Lite (34-00297.2) Product Manual Uživatelský manuál stáhnout pdf (Strana 12)

6 C

HAPTER

2: I

NSTALLATION

AND

ONFIGURATION

Wallmount

Installation

Using Adhesive Strips

1 Select a place close to an AC outlet with clearance for the signal

and power cables. The indicators and switches should be easily

accessible.

2 Verify the mounting surface is clean.

3 Cut the adhesive strip to the desired length and affix the backing

of one piece to the underside of the unit.

4 Attach the other adhesive strip to the piece on the underside of

the unit.

5 Remove the backing to expose the sticky surface.

6 Press the underside of the unit firmly against the selected place.

Using Screws

1 Select a place close to an AC outlet with clearance for the signal

and power cables. The indicators and switches should be easily

accessible.

2 Vertically place two #6 screws 3-13⁄32 inches apart at the

selected place. Leave the screws out about an eighth of an inch.

3 Place the upright unit over the screws until the holes engage and

slide the unit down until it locks.

Connections

The S Lite has female DB-25 connectors for the DCE and DTE

interfaces, and a power connector. The following paragraphs

describe these connections.

DCE and DTE

Connections

Table 2-1 shows the pinout for the DCE and DTE connectors.

Table 2-1 DCE and DTE Connector Pinout

Pin DCE and DTE Pin DCE and DTE

1 Shield Ground 14 TXD B

2 TXD A 15 TXC A

3 RXD A 16 RXD B

4RTS A 17 RXC A

5CTS A 18 LL

6DSR A 19 RTS B

7 Signal Ground 20 DTR A

8DCD A 21 RL

9RXC B 22 DSR B

10 DCD B 23 DTR B

11 SCTE B 24 SCTE A

12 TXC B 25 TM

13 CTS B

1 2 ... 7 8 9 10 11 12 13 14 15 16

Komentáře k této Příručce

Žádné komentáře

Verilink S Lite (34-00297.2) Product Manual Uživatelský manuál Strana 12

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Verilink S Lite (34-00297.2) Product Manual