Verilink WANsuite 5130 (34-00298.L) Product Manual Uživatelský manuál stáhnout pdf (Strana 178)

4-50 WANsuite 5160/5130

Rule Configuration Screen

Select from the <Ndx> column to bring up the Rule Config screen (Figure

4.43) to establish Service Aware parameters. To establish a rule, select the

desired rule configuration options, provide the appropriate filter information

where required, and press the “Esc” key.

Figure 4.43

Rule Config Screen

The paragraphs below describe the rule configuration parameters and their

options.

Service

Selects the service to which the rule applies.

NOTICE: If you change the Service parameter, you must press the “Enter” key to

see the appropriate DLCIs.

DLCI

Selects the DLCI to which the rule applies.

Filter By DLCI

Enables or disables filtering of the IP traffic in accordance with the previously

specified DLCI.

NOTICE: To use this filter, you must specify both the Service and DLCI

parameters in the rule configuration.

IP Address

Establishes the IP address by which the rule will filter IP traffic (if enabled).

IP Mask

Represents a range of IP addresses defined so that only machines with IP

addresses within the range defined by the mask are allowed to access an

Internet service. To mask a portion of the IP address, replace it with the wild

card character “0” (zero). (For example, 192.44.0.0 represents every computer

on the Internet with an IP address beginning with 192.44.)

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 262 263

Žádné komentáře

Verilink WANsuite 5130 (34-00298.L) Product Manual Uživatelský manuál Strana 178