Verilink WANsuite 5130 (34-00298.L) Product Manual Uživatelský manuál stáhnout pdf (Strana 179)

VT100 Interface 4-51

Filter By IP Address

Enables or disables filtering of the IP traffic by the IP address specified in the

IP Address or IP Mask field.

Enter IP Port or Select

From List

Establishes the IP port by which the rule will filter IP traffic (if enabled).

Filter By IP Port

Enables or disables filtering of the IP traffic by the IP port specified in the IP

Port field.

Tx Alarm Threshold

Specifies the threshold in bits per second for the Transmit Alarm on this rule.

Tx Alarm

Shows the current Transmit Alarm status.

Traffic Meter Statistics Screen

The Traffic Meter Statistics screen (Figure 4.44), which can be accessed from

the bottom of the Rule Config screen, displays the number of frames and

octets sent over a DLCI that have been counted in accordance with the

Service Aware “rule” that has been established for a Service. As such, it is

frame relay specific (i.e., DLCIs only occur in frame relay links). In addition,

this screen provides data rate performance information for the period of time

you have specified in the Period field (see below).

Figure 4.44

Traffic Meter Statistics Screen

The Traffic Meter Statistics screen reports on the following parameters:

• Tx Frames

• Tx Octets

• Rx Frames

• Rx Octets

• Rate Peak – the peak data rate for the viewed period (see below)

• Rate Average – the average data rate for the viewed period (see below)

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 262 263

Žádné komentáře

Verilink WANsuite 5130 (34-00298.L) Product Manual Uživatelský manuál Strana 179