Verilink WANsuite 5370 (34-00310.D) Product Manual Uživatelský manuál Strana 129

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 235
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 128
VT100 Interface 4-13
Figure 4.10
Ethernet (IP Details) Screen
Unit IP Address
A unique Network address assigned to this unit.
Subnet Mask
Defines the Network portion of the unit’s IP address.
Gateway IP Address
IP address of the default gateway (router) on the LAN side of the unit.
DHCP Client
If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
Client Identifier
Displays a unique identifier for a specific IP address.
Ethernet
Enables or disables a remote unit’s Ethernet port.
Physical Address
Displays unique MAC address.
NOTICE: Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.
NOTICE: If you manually change the IP address, you must “Save and Restart.
(See Save and Restart on page 4-6.)
Select the Unit Access Table prompt on the Ethernet (IP Details) screen to
view the Unit Access Table (Figure 4.11), which specifies up to 10 different
IP networks that may access the unit. Select an <Ndx> number on the table to
view the Unit Access Details (Figure 4.12) for that number.
Zobrazit stránku 128
1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 234 235

Komentáře k této Příručce

Žádné komentáře