Verilink WANsuite 5370 (34-00310.D) Product Manual Uživatelský manuál Strana 213

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 235
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 212
Front Panel LCD Interface 5-15
Parity
Sets the parity bit.
Values: None, Odd, Even
Default: None
Stop Bits
Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
DTR Alrm
Setting DTR Alrm to “En” allows the unit to go into alarm on a loss of DTR.
Values: Dis, En
Default: Dis
Diag Msgs
Enables the Supervisory port to send out diagnostic messages upon power-up.
Values: En, Dis
Default: En
NOTICE: When in SCADA mode, these diagnostic messages disrupt the connected
device. Therefore, if using the SCADA mode, set this value to
“Disable.”
Auxiliary Configuration Menu
The AUXILIARY configuration menus let you view and make changes to the
unit’s Auxiliary interface configurations as described below.
Figure 5.14
Auxiliary Configuration Menu Tree
Speed
Changes the Auxiliary port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 9600
Ch Size
Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
9600
1200
2400
4800
19200
38400
57600
115200
Speed Ch Size Parity Stop Bits DTR Alrm
8
5
6
7
None
Odd
Even
1
2
Dis
En
Aux
Config
Zobrazit stránku 212
1 2 ... 208 209 210 211 212 213 214 215 216 217 218 ... 234 235

Komentáře k této Příručce

Žádné komentáře