Verilink WANsuite 5370 (34-00310.D) Product Manual Uživatelský manuál Strana 131

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 235
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 130
VT100 Interface 4-15
Figure 4.13
Supervisory Config Screen
The Supervisory screen lets you view and change the Supervisory port speed
used by PPP and VT100. The Supervisory port only supports asynchronous
character formats.
Speed
Changes the Supervisory port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 19200
Character Size
Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Parity
Selects the parity bit.
Values: None, Odd, Even
Default: None
Stop Bit
Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
DTR Alarm Control
Setting DTR Alarm Control to “Enable” allows the unit to go into alarm on a
loss of DTR.
Values: Disable, Enable
Default: Disable
DTR Alarm Status
Indicates the current state of the DTR alarm.
Diagnostic Msgs
Enables the Supervisory port to send out diagnostic messages upon power-up.
Values: Enable, Disable
Default: Enable
NOTICE: When in SCADA mode, these diagnostic messages disrupt the connected
device. Therefore, if using the SCADA mode, set this value to
“Disable.”
Zobrazit stránku 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 234 235

Komentáře k této Příručce

Žádné komentáře