Verilink WANsuite 7105 (34-00316.C) Product Manual Uživatelský manuál Strana 131

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 255
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 130
Web Server Interface 3-99
Configuration.” The WANsuite unit will reset, after which it will use the
uploaded configuration.
To install software, click on the “Browse” button to select the file you want
installed. Then click on “HTTP Software Install.”
NOTICE: Make sure you allow sufficient time for the installation to occur.
Canceling the installation before it has fully executed will result in the
new software NOT being installed into the unit.
Figure 3.99
Upload/Save Screen
TFTP Configuration
A Trivial File Transfer Protocol (TFTP) service on a server can provide
remote file access to the WANsuite 7105 to
Update the firmware on a WANsuite unit
Save the configuration setup of a WANsuite unit
Restore a saved configuration setup to a WANsuite unit
To transfer a file to or from a TFTP server from a WANsuite unit, you must
indicate the TFTP server’s IP address, the file name, and then perform a Get
operation to receive a file from the server, or a Put operation to send a file to
the server. The file name and its extension determine the type of file
transferred.
The table below shows the possible file operations.
Operation Filename Extension Action
Update Application Firmware .CHX or .HEX(1) Get
Update Boot Firmware .HEX(2) Get
Zobrazit stránku 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 254 255

Komentáře k této Příručce

Žádné komentáře