Verilink 8100A (34-00237) Product Manual Uživatelský manuál stáhnout pdf (Strana 217)

Reports 5-33

The spanning state timer value is for listening or learning states and counts

down from the forward delay time to zero.

The hello timer value is valid only if the active port is the Root Bridge of the

network. It counts down from the hello time to zero.

• Root priority − priority of the root bridge on the network.

• ID − Ethernet MAC address of the root bridge on the network.

Press any key to return to the Reports menu.

PPP Authorization Entries Report

Type “P” on the Reports menu to display information about PPP

authorization entries. If no PPP authorization entries have been created, the

IAD displays a message to confirm this.

Otherwise, the information shown in the table below is displayed for each

entry.

Press any key to return to the Reports menu.

System Uptime Report

Type “U” on the Reports menu to display the amount of time elapsed since

the IAD was reset.

Press any key to return to the Reports menu.

Memory Statistics Reports

Type “O” on the Reports menu to display the Memory Statistics menu. The

Memory Statistics menu (1-O) contains two memory display commands:

Designated designated port for the bridge—yes | no

Timers current values of the spanning state timer (first

value) and the hello timer (second value)

Parameter Description

Authorization type None | Password Authentication Protocol (PAP)

Client | PAP Server |Challenge Handshake

Authentication Protocol (CHAP) Client | CHAP

Server

Slot #/Interface #/Port # active slot for the PPP interface

Userid/Password/Peer Name values for the PPP interface

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 310 311

Žádné komentáře

Verilink 8100A (34-00237) Product Manual Uživatelský manuál Strana 217